基于ANSYS的磁悬浮转子的模态分析*

作者：李克雷，谢振宇 日期：2008-02-25/span> 浏览：3279 查看PDF文档

基于ANSYS的磁悬浮转子的模态分析*

李克雷，谢振宇
(南京航空航天大学 机电学院，江苏 南京 210016)

摘要：以磁悬浮轴承转子系统的组成及工作原理为基础，在ANSYS9.0中建立了磁悬浮转子的三维有限元模型。采用Subspace法计算了前4阶固有频率和振型，并与试验模态分析结果进行了对比。结果显示，基于有限元法得到的数据与试验模态分析基本一致，所建立的有限元模型为柔性转子系统设计提供了一定的理论依据。
关键词：磁悬浮轴承；试验模态分析；有限元法；临界转速
中图分类号：TH133文献标识码：A文章编号：1001-4551(2008)01-0001-03

Model analysis of the magnetic suspension rotor based on ANSYS
LI Kelei, XIE Zhenyu
(College of Mechanical and Electrical Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 210016, China)
Abstract: Based on the principle of active magnetic bearing system, a 3Dfinite element model of the rotor was established by ANSYS9.0. Initial four order natural frequencies and vibration model shapes were calculated by method of Subspace, and compared with the results of experimental modal analysis. Analysis shows that the results obtained by experimental model analysis(FEA) are basically consistent with that by finite element method(EMA). It provides realiable theoretical basis for flexible rotor system design.
Key words: magnetic bearing (MB); experimental model analysis (EMA); finite element method (FEA); critical speeds

参考文献(Reference):
［1］SCHWEITZER G, BLEULER H, TRAXLER A.主动磁轴承基础、性能及应用［M］.虞烈，袁崇军，译.北京：新时代出版杜，1997.
［2］曹树谦，张文德，萧龙翔．振动结构模态分析：理论、实验与应用［M］．天津：天津大学出版社，2001.
［3］周朝暾，汪希平，严慧艳．主动电磁轴承转子振动模态的分析研究［J］．机械科学与技术,2004,23(10):1163-1165.
［4］孙首群，虞烈.磁轴承柔性转子系统动力特性建模与优化仿真［J］．系统仿真学报,2003,15(3)：365-368.
［5］欧阳华，李群明，段吉安，等．两级磁悬浮工作平台的动力学建模及模态分析［J］．自动化与仪表,2007（2）:1-5.
［6］王靖岳，丁旺才，王浩天．基于Pro／E和ANSYS的曲轴有限元分析［J］．机械工程与自动化,2007(1):54-56.
［7］ZHAO Lei, LI Hongwei. Investigations of an AMBs—Flexible Rotor for Pass through Two Bending Mode Frequencies［C］.  Proc.of the 10th International Symposium on Magnetic Bearings, CDROM,2006.
［8］ITO M, FUJIWARA H, MATSUSHITA O. Rotational Test of Flexible Rotor Supported by Active Magnetic Bearings (Passing the 3rd Bending Critical Speed)［C］. Proc.of the 10th International Symposium on Magnetic Bearings,CDROM,2006.