基于WinCC与S7300的深孔电镀监控系统

作者：周 杰，潘宏侠，郭彦青 日期：2008-04-17/span> 浏览：3358 查看PDF文档

基于WinCC与S7300的深孔电镀监控系统
周 杰，潘宏侠，郭彦青
（中北大学 机械设计及自动化学院，山西 太原 030051）

摘 要：介绍了如何利用西门子组态软件WinCC及S7300 PLC实现深孔电镀系统的自动化。主要介绍了该自动控制系统的软硬件组成、网络结构、系统功能及特点，重点阐述了动态人机界面的建立和控制算法的研究。该系统集成了自动控制和远程监控的优点，并保留了现场的手动电气控制，使得电镀系统的运行更加灵活稳定。该系统自运行以来，各项功能正常，达到了设计的要求。
关键词：WinCC；可编程逻辑控制器；电镀系统；自动控制；人机界面

Deep hole electroplating monitor system based on WinCC and S7300
ZHOU Jie, PAN Hongxia, GUO Yanqing
(College of Mechanical Engineering & Automation,North University of China, Taiyuan 030051, China)

Abstract: The way to realize the automation of deep hole electroplating system by means of SIEMENS configuration software WinCC and S7300 PLC was introduced. The main concern is to introduce the configuration of software and hardware, network construction and function and characteristics of the automation system. It especially draws great attention to the establishment of dynamic HMI (Human Machine Interface) and the research of the control algorithm. This system not only combines the advantages of automatic control and remote control but also remains spot manual electrical control. Thus, the electroplating system works in a more stable as well as flexible way. The systems every function works well, and the devices operate steadily since system run into automatic operation, so it has reached the design requirement completely.
Key words: windows control center (WinCC); programmable logic controller (PLC); electroplating system; autocontrol; human machine interface (HMI)

参考文献(Reference):
［1］王万强，陈国金，张俊芳.S7300PLC和WinCC组态软件在电厂的应用［J］.机电工程，2004，21(7):4-7.
［2］SIEMENS AG. SIMATAC MicroComputing User Manual［M］. ［S.l.］:2000.
［3］SIEMENS AG. SIMATAC S7300 Programmable Controller System Manual［M］. ［S.l.］:2000.
［4］朱 勇，叶 华，刘成良.使用WinCC在机电一体化系统中实现过程监控［J］.仪表技术与传感器，2004(6):20-25.
［5］颜文俊,毛雪珍.基于PLC与WinCC的电站远程自动监控系统设计［J］.机电工程,2005,22(3):33-36.
［6］苏昆哲.深入浅出西门子WinCC V6［M］.北京：北京航空航天大学出版社，2004.
［7］赵山林，高 媛.C程序设计［M］.北京：人民邮电出版社，2004.