Introduction

International Standard Serial Number:

ISSN 1001-4551

Sponsor:

Zhejiang University;

Zhejiang Machinery and Electrical Group

Edited by:

Editorial of Journal of Mechanical & Electrical Engineering

Chief Editor:

ZHAO Qun

Vice Chief Editor:

TANG ren-zhong,

LUO Xiang-yang

Tel:

86-571-87041360,87239525

Fax:

86-571-87239571

Add:

No.9 Gaoguannong,Daxue Road,Hangzhou,China

P.C:

310009

E-mail:

meem_contribute@163.com

Jetting control system of continuous gray micro-droplet
Published:2015-06-10 author:LU Ling-feng，ZHAN Hong-wu，XV Fang Browse: 3324 Check PDF documents

 Jetting control system of continuous gray micro-droplet

LU Ling-feng，ZHAN Hong-wu，XV Fang
（Key Laboratory of E&M，Ministry of Education & Zhejiang Province，Zhejiang University of Technology，
Hangzhou 310014，China）
Abstract：Aiming at the problems of big data to process and transmission rate mismatch in gray micro-droplet jetting technology，after
the analyse of the characteristics and control method of grayscale micro-droplet jetting technology，a gary micro-droplet jetting control
system base on ARM and FPGA architecture and dual port RAM ping-pang operating technology was presented. The timing simulation of
FPGA internal module was established based on Modelsim software. The gray levels and edages swatooth were tested on the gray microdroplet
jetting experiment platform.The results indicate that the system can achieve the maximum width of 280 mm and 8 grayscale microdroplet
jetting and the printed image edges are sharp and clear with no obvious swatooth.
Key words：continuous grayscale；micro-droplet jetting；control system
Advanced Search
Online Office System
  • Chinese Core Periodicals
  • Chinese Sci-tech Core Periodicals
  • SA, INSPEC Indexed
  • CSA: T Indexed
  • UPD:Indexed


2010 Zhejiang Information Institute of Mechinery Industry

Technical Support：Hangzhou Bory science and technology

You are 1895221 visit this site