International Standard Serial Number:

ISSN 1001-4551

Sponsor:

Zhejiang University;

Zhejiang Machinery and Electrical Group

Edited by:

Editorial of Journal of Mechanical & Electrical Engineering

Chief Editor:

ZHAO Qun

Vice Chief Editor:

TANG ren-zhong,

LUO Xiang-yang

Tel:

86-571-87041360,87239525

Fax:

86-571-87239571

Add:

No.9 Gaoguannong,Daxue Road,Hangzhou,China

P.C:

310009

E-mail:

meem_contribute@163.com

Modeling and optimization design of cutting angle for honeycomb material
Published:2018-01-10 author:LU Yong-bo1, WANG Ding-sheng1, LI Bin-sheng1, NI Jing1,2, LI Bin1,2 Browse: 2273 Check PDF documents

Modeling and optimization design of cutting
angle for honeycomb material

LU Yong-bo1, WANG Ding-sheng1, LI Bin-sheng1, NI Jing1,2, LI Bin1,2

                                                    (1. Zhejiang Julihuang Sawing Machine Share Co.Ltd., Lishui 321404, China;
                                                  2. Key Laboratory of Mechanical Equipment and Technology for Marine Machinery,
                                                       Hangzhou Dianzi University, Hangzhou 310018, China)

Abstract: Aiming at solving sawing efficiency problems of the honeycomb denitration catalyst material, which caused by its high brittleness, the sawing load, sawing angle and sawing energy were studied. The structure discontinuity characteristics was reorganized and summarized. Based on classical sawing load modeling theory and a large number of sawing experiment, a design of the optimal sawing angle was proposed to realize high efficiency sawing. The sawing load was taken as the comparison object. The sawing load model based on the cutting angle was established, and the optimal sawing angle was obtained. The sawing experiments were carried out at various angles. The results indicate that the sawing load of 45° was obviously less than that of both sides. At the same time, from the perspective of the sawing load amplitude distribution, the sawing load fluctuation of 45° was obviously less than the value of 35° and 55°, which means its has a optimal stability.
Key words: saw cutting; denitrification catalyst; high efficiency


  • Chinese Core Periodicals
  • Chinese Sci-tech Core Periodicals
  • SA, INSPEC Indexed
  • CSA: T Indexed
  • UPD:Indexed

Copyright 2010 Zhejiang Information Institute of Mechinery Industry All Rights Reserved

Technical Support:Hangzhou Bory science and technology

You are 1895221 visit this site